Signal Generators and Sources
to create and rate content, and to follow, bookmark, and share content with other members.
FAQ: Are there any S1 S2 measurements with power sensors on EXG and MXG?
Question asked by
on Dec 18, 2012
on Dec 18, 2012 by tabbott
Show 0 Likes
*X-Series EXG and MXG FAQ’s*
Question: Are there any S1 S2 measurements with power sensors on the X-Series signal generators?
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Dec 18, 2012 3:03 PM
Answer: No, however “User” channel correction routine in X-Series vector signal generators measure DUT channel response in phase and amplitude with power sensor. A real-time 256 tap digital filter then applies a complex inverse response to correct any linear errors . The result is a flat phase and amplitude response across the modulation bandwidth. See data sheet for more details.
Show 0 Likes
Retrieving data ...
Scope firmware for 90000 Series;Windows XP operating system It is running 1.20 now. upgrade to the latest software is 4.20
COM automation and Logic Analyzer Software 5.90
Firmware upgrade for Agilent 54825A oscilloscope
Quickly implementing several automotive electrical disturbances based on the ISO 16750-2 standard
Power Supply Current Output Lag