AnsweredAssumed Answered

6032A 60V/50A 1000W Trouble-shooting

Question asked by wp_mbi on Sep 7, 2010
Latest reply on Sep 10, 2010 by carlp

Like • Show 0 Likes0
Comment • 4

Hi,

I have a few 6032A's with various problems. On one supply the front panel indicator lights all come on, but never go off. On two others, the supplies go into over-range error mode at < 1W. I also have two that go into over-range error mode at just over 300W of output.

Any suggestions?

Thanks.

No one else has this question

Outcomes

4 Replies

carlp Sep 8, 2010 1:13 PM
Mark Correct
Correct Answer
Hello
I have recieved your message and will do some reasearch and get back to you in a day or so!
Like • Show 0 Likes0
Actions
carlp Sep 10, 2010 9:20 AM
Mark Correct
Correct Answer
The Question: On one supply the front panel indicator lights all come on, but never go off. On two others, the supplies go into over-range error mode at < 1W. I also have two that go into over-range error mode at just over 300W of output.

See the suggestions listed below.

The one which stays stuck with all the LEDs could be as simple as the unit wired for 230Vac but connected to the wall at 115Vac.

The Control and GP-IB can do that also.

Most of the time we see blown FET boards as the highest rate of damaged assemblies due to internal line voltage mis-setting still at 115 Vac and then plugged into 230Vac external source.

http://cp.literature.agilent.com/litweb/pdf/5959-3344.pdf
Like • Show 0 Likes0
Actions
carlp Sep 10, 2010 9:27 AM
Mark Correct
Correct Answer
Hello
The URL shown above is the Service manual and it contains lots of information that can be used to repair this instrument.
Like • Show 0 Likes0
Actions
carlp Sep 10, 2010 9:25 AM
Mark Correct
Correct Answer
I hope the information provide helps to solve the problem described. Have a nice day!
Like • Show 0 Likes0
Actions

6032A 60V/50A 1000W Trouble-shooting

Outcomes

Related Content

Recommended Content