to create and rate content, and to follow, bookmark, and share content with other members.
Problem with saving s2p files using scpi command
Question asked by
on Oct 18, 2012
on Oct 19, 2012 by odanzy
Show 0 Likes
I wish to save trace into s2p files using programming commands. My model is ENA E5070B. What is the correct command for saving s2p files? Please advice.
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Oct 19, 2012 10:49 AM
The command is :MMEM:STOR:SNP from the E5071B Programmer's Guide ([http://cp.literature.agilent.com/litweb/pdf/E5070-90412.pdf]). You will need to have at least firmware 6.50 to have that functionality in firmware.
Edited by: odanzy on Oct 19, 2012 1:48 PM
Show 0 Likes
Retrieving data ...
GPIB/SCPI Commands wtih Agilent E8361A
SystemVue Connected Solution (Connected to Keysight Instruments)
Connecting SystemVue to Test Instruments for DPD Measurement
How to choose the right optical power meter for 850 nm signals
On a E4438C when using a PRAM file for data I was able to add a data bit with non burst too turn off the carrier. I can not seem to do this with the N5182B using the same PRAM file. How do I turn off the RF?