AnsweredAssumed Answered

Command for the LCR meter is not responding in hyperterminal

Question asked by hari516 on Feb 22, 2012
Latest reply on Feb 23, 2012 by lhornburg
Hi,

I would like to communication the LCR meter through hyperterminal. I had set the baud rate as per the

LCR -meter but still i Could not communicate.It has only RS232 connection not GPIB Interfcace.

Communication PDF was downloaded from the LCR -800 series website.

The command i typed in hyperterminal was COMU?<^END^M> then enter

If the device is on then  it will show COMU:ON if not COMU:OFF..but where as here neither of those

result was shown ..I could not get what was wrong and didnt respond any thing.

Kindly let me know how to communicate through commands in hyperterminal.

Thanks In advance  

Outcomes