AnsweredAssumed Answered

vrf DTR control of serial port

Question asked by VRFuser on Aug 6, 2007
Latest reply on Aug 10, 2007 by VRFuser
Hello all,

            Is it possible to toggle / control the state of the serial port DTR line within VEE.  I’ve tried using the direct IO write -> IOcontrol which allow selection of DTR and RTS, but when run I get an error 811.  The help makes reference that the IOCONTROL is only for GPIO, yet the pull down allows selection of DTR & RTS.

 

Thanks, for any help shedding light on this issue

 

Pete Thomas

Senior Test Engineer

MR Test Engineering

• Phone: 262.521.6758

• Mobile: 262.993.0154

• Pager: NONE

• e-mail: HYPERLINK "mailto:Peter.Thomas@med.ge.com"Peter.Thomas@med.ge.com

GE Healthcare

 


---
You are currently subscribed to vrf as: hua_jing@agilent.com
To subscribe please send an email to: "vrf-request@lists.it.agilent.com" with the word subscribe in the message body.
To unsubscribe send a blank email to "leave-vrf@it.lists.it.agilent.com".
To send messages to this mailing list, email "vrf@agilent.com".
If you need help with the mailing list send a message to
"owner-vrf@it.lists.it.agilent.com".
Search the "unofficial vrf archive" at "http://www.vrfarchive.com/vrf_archive".
Search the Agilent vrf archive at "http://vee.engineering.agilent.com".  

Outcomes