AnsweredAssumed Answered

vrf vrf Comm port not open

Question asked by VRFuser on May 2, 2008
  • Comment • 0
I have a test system which talks to a mobile phone over a com port.  Every now and again it stops with a com “port not open” error.  Power cycling the phone releases it but this can’t be done remotely in our set up.   Does anyone have a simple way to disable and then enable a com port?  I can reboot the phone remotely but a reboot is not the same as a power cycle.

 

I would be grateful for any hints.

 

Adam Kohler

SVV

Mobile Broadband Division

Agilent Technologies

South Queensferry

Scotland

 

telnet 313 2138

t +44 131 331 7138

e HYPERLINK "mailto:adam_kohler@agilent.com"adam_kohler@agilent.com

 

Agilent Technologies UK Limited, Registered Office: 710 Wharfedale Road, Winnersh Triangle, Wokingham, Berkshire, RG41 5TP - Registered No. 03809903

 


---
You are currently subscribed to vrf as: ming_meng@agilent.com
To subscribe please send an email to: "vrf-request@lists.it.agilent.com" with the word subscribe in the message body.
To unsubscribe send a blank email to "leave-vrf@it.lists.it.agilent.com".
To send messages to this mailing list, email "vrf@agilent.com".
If you need help with the mailing list send a message to
"owner-vrf@it.lists.it.agilent.com".
Search the "unofficial vrf archive" at "http://www.vrfarchive.com/vrf_archive".
Search the Agilent vrf archive at "http://vee.engineering.agilent.com".  
No one else has this question

Outcomes