AnsweredAssumed Answered

How to Apply Power Cal to Cal Set?

Question asked by swninja on Apr 4, 2013
Latest reply on Apr 8, 2013 by Dr_joel
Hello,

I am controlling an N5222A using SCPI commands. I am able to perform and save a simple source cal, and then perform and save an ECal calibration. However, the resulting Cal Set only contains the ECal calibration and not the Power Cal (when I look at the Cal Set information, I see "4P/1-2-3-4" instead of the expected "4P+/1-2-3-4". It seems an extra step is needed to apply the Power Cal to the Cal Set. Does anyone know how to do this?

Regards,

Ashley  

Outcomes