AnsweredAssumed Answered

How to Initiate User Flatness Correction

Question asked by swninja on Apr 11, 2013
Latest reply on Aug 11, 2017 by danflurry
Hello,

I am using SCPI commands to remotely control an E8527D Signal Generator. I am attempting to create and apply a Flatness Correction table using SCPI, analogously to the procedure in the Signal Generator User's Manual pp 76-77 (attached). I found the commands to configure the system for the Power Meter, but I cannot find the command to initiate the User Flatness Calibration using the Power Meter.

Manually, the command is:
Amplitude --> User Flatness --> Do Cal

Does anyone know the SCPI command to initiate this calibration?

Regards,

Ashley  

Outcomes