AnsweredAssumed Answered

HP 8114A 100V / 2A Pulse Generator - Command executed ?

Question asked by Pierre447 on Mar 22, 2013
Latest reply on Apr 17, 2013 by Pierre447
Hello,

I have a small matter with the instrument control of my HP 8114A.
My wish is to  :
1 - send a command to change the voltage of the generator
2 - check if the command has been properly executed. If not then I should wait until the command is done.

For the first part, I allready figure it out with the following SCIPI command :
*SOUR:VOLT 80V*

For the second part I think a solution is :
**OPC?*

My problem is that the execution of the last command and the readout time is long (around 500ms I would say). Is there a quicker way to do it ?  

Outcomes