AnsweredAssumed Answered

MXA N9020A Calibration Operation Complete Question

Question asked by tom003 on Jul 11, 2012
Latest reply on Jul 30, 2012 by tabbott
I am checking the Status:Questionable:Calibration:Condition register.
When the return value is 16384, I know I need to calibrate the unit.
I then issue the command Calibrate:All
No problems so far, everything is working as expected.

The issue is then calling "*OPC?" to determine if the cal process is complete, results in a timeout error.
Why a timeout error? or How do I go about determining when the calibration is complete?

Thanks in advance.