Power Meters and Sensors
to create and rate content, and to follow, bookmark, and share content with other members.
Question asked by
on Jan 13, 2012
on Jan 13, 2012 by lynchdavidb
Show 0 Likes
Power sensor cal factors are tested at various points across their frequency range. A value and uncertainty can be assigned to these readings. Is their any material available to help in assigning uncertainties to interpolated cal factors?
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Jan 13, 2012 2:37 PM
The power meters apply a straight line interpolation between each adjacent cal factor point frequency when you are testing a frequency that is not at a designated cal factor frequency. The cal factor uncertainty is also a straight line interpolation between the same two adjcent cal factor points.
Show 0 Likes
Retrieving data ...
How can I use a third party automatic calibration kit with the Agilent PNA E8362B?
IVI Driver for N7714A Four-Port Tunable Laser System Source
20200312_Be Ready for PCIe Gen5 Design Challenge
SystemVue support import CST antenna pattern file only suffix for FFS file format?It can support other format file?
Modeling of GaN with $table_model in ADS using verilog-ams