Occasionally we calibrate 3458's that have been stored for a period or only used in one mode.
Certain problems or out of tolerance conditions can be overcome after excercising internal relays
by changing mode, range, etc. I am going to write a simple automated routine to do this so that it
may be looped as many times as desired.
My question is; will stepping through all the modes and ranges cover all the relays? Is there anything more that could be done?
Any ideas would be appreciated.
Thanks
Edited by: wilber on Jan 16, 2013 12:00 PM
Certain problems or out of tolerance conditions can be overcome after excercising internal relays
by changing mode, range, etc. I am going to write a simple automated routine to do this so that it
may be looped as many times as desired.
My question is; will stepping through all the modes and ranges cover all the relays? Is there anything more that could be done?
Any ideas would be appreciated.
Thanks
Edited by: wilber on Jan 16, 2013 12:00 PM