AnsweredAssumed Answered

Internal Error running probe selection (UX 5.21 103)

Question asked by GeOrGe_GDL on Apr 16, 2012
Latest reply on Apr 24, 2012 by adrianc
When I am trying to run probe selection on a 8up panelized boards, it starts and after 1 or 2 nodes has been analyzed it gives me the following error:

Selecting probes for board "WPAN_R243%1"


Node "1%U3-43" is inaccessible because it has no accessible
   probing locations.  Please see the Nodes Needing More Probes
   report in the details file for further information.
(WARNING PBS124)

Node "1%U7-3" is inaccessible because it has no accessible
   probing locations.  Please see the Nodes Needing More Probes
   report in the details file for further information.
(WARNING PBS124)

Node "1%U7-5" is inaccessible because it has no accessible
   probing locations.  Please see the Nodes Needing More Probes
   report in the details file for further information.
(WARNING PBS124)

Probe Select was not able to put enough probes on node "1%GND".
   Please see the Nodes Needing More Probes report in the details file
   for further information.
(WARNING PBS77)

*Internal error 119/4/0 has occurred.  Please contact Agilent Technologies.*

I checked the GND node and it has 3 probes per board.

could anyone tell me what error msg means? how can I fix it? 

Thank you
GeOrGe_GDL  

Outcomes