to create and rate content, and to follow, bookmark, and share content with other members.
vrf AW: Error Handling
Question asked by
on Jan 16, 2003
Show 0 Likes
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Jan 15, 2003 4:27 PM
yes I implemented some small error handling in most of my instrument IOs.
Usually I put the directIO command with an added error output pin in a loop.
If an error occurs, the error and the name of the instrument is displayed in
a dialog box, where you have the possibility to select a retry button. This
button restarts the loop (and the direct IO command) with the NEXT command.
If the directIO command runs with no error, the loop is directly exited with
a stop command.
Hope this helps,
> -----Ursprngliche Nachricht-----
> Von: Cagri Acar [SMTP:firstname.lastname@example.org]
> Gesendet am: Donnerstag, 16. Januar 2003 07:17
> An: VEE vrf
> Betreff: [vrf] Error Handling
> Hi there,
> Did anyone out there thought of error handling mechanisms for the
> instrument IO in VEE? I want the create properly operating VEE programs
> which do not stop because of errors but give necessary instructions to the
> operator to correct the errors if possible. Or let me ask you: Do you care
> for errors and methods to mitigate them during run-time? If yes how?
> Cagri Acar
> Test Engineer
> Aselsan AS
> PK101 Yenimahalle/Ankara TR
You are currently subscribed to vrf as:
To subscribe send a blank email to "email@example.com".
To unsubscribe send a blank email to "firstname.lastname@example.org".
To send messages to this mailing list, email "email@example.com".
If you need help with the mailing list send a message to "firstname.lastname@example.org".
Show 0 Likes
Retrieving data ...
The remote control problem in Agilent 8960
8960 W-CDMA Inner loop
8960 Series 10 Basics
vrf VEE Close Down
Libraries for Agilent 8960 E5515C and CMW500