Hello all...
Does any one know how to change com port setting by HPVee its self ?
I mean, my program has to change the eg. baud rate ?
Yours Sincerely
NEG Micon Control Systems A/S
Anders Jensen
Design Engineer
Development Electronic Hardware
Italiensvej 1 - 5
DK-8450 Hammel
Denmark
Tel: +45 8762 2600
Fax: +45 8762 2601
Direct: +45 8762 2616
Cellular: +45 2060 5916
E-mail: abj@control-systems.com
---------------------------------------------------------------------
This is the "vrf" maillist, managed by Majordomo. To send messages to
this maillist, just email to "vrf@lvld.agilent.com". Subscriptions and
unsubscriptions are done through the address "vrf-request@lvld.agilent.com".
If you need details, just send a message containing the text "help"
to "vrf-request@lvld.agilent.com".
---------------------------------------------------------------------
Does any one know how to change com port setting by HPVee its self ?
I mean, my program has to change the eg. baud rate ?
Yours Sincerely
NEG Micon Control Systems A/S
Anders Jensen
Design Engineer
Development Electronic Hardware
Italiensvej 1 - 5
DK-8450 Hammel
Denmark
Tel: +45 8762 2600
Fax: +45 8762 2601
Direct: +45 8762 2616
Cellular: +45 2060 5916
E-mail: abj@control-systems.com
---------------------------------------------------------------------
This is the "vrf" maillist, managed by Majordomo. To send messages to
this maillist, just email to "vrf@lvld.agilent.com". Subscriptions and
unsubscriptions are done through the address "vrf-request@lvld.agilent.com".
If you need details, just send a message containing the text "help"
to "vrf-request@lvld.agilent.com".
---------------------------------------------------------------------