AnsweredAssumed Answered

vrf Configuring LAN instruments

Question asked by VRFuser on Apr 6, 2003

How does a person configure an instrument I/O for LAN?  I'm trying to
connect to a 6K controller through an RJ-45 LAN connection using the
Instrument manager.  I configured it with GPIO, gateway - I used the IP
address of the controller but when I tie it to an address, it errors out
with "device not configured".  I'm using Vee 5.0


Lenny Hill
Manufacturing / Test Engineer - New Product Introduction

You are currently subscribed to vrf as:
To subscribe send a blank email to "".
To unsubscribe send a blank email to "".
To send messages to this mailing list,  email "". 
If you need help with the mailing list send a message to "".