AnsweredAssumed Answered

vrf How to auto re-establish LAN I/O session using VEE 7.5

Question asked by VRFuser on May 30, 2006
Hi team;
 
I’m using VEE 7.5 to develop Power cycle test communicate thru LAN TCPIP. Each time my DUT is power cycled (after being powered OFF for 10 minutes), the VEE error 814 came out with message below;
 
“Lock acquisition failed on Unit1, at interface (TCPIP::unit1.mys.ikramatic.com::inst0::INSTR), Direct I/O)â€
 
I checked in VEE help file, it mentioned about VISA lock/unlock settings, but I couldn’t find specific on it…
 
Do you have any clue on this? Where should I change its setting if using Agilent I/O Suite 14.1?
 
Hope you can help advice on this.
 
Thanks

Regards,
Shidi

__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com ---  To subscribe please send an email to: "vrf-request@lists.it.agilent.com" with the word subscribe in the message body. To unsubscribe send a blank email to "leave-vrf@it.lists.it.agilent.com". To send messages to this mailing list, email "vrf@agilent.com". If you need help with the mailing list send a message to "owner-vrf@it.lists.it.agilent.com". Search the "unofficial vrf archive" at "www.oswegosw.com/vrf_archive/".  

Outcomes