AnsweredAssumed Answered

vrf representation in vee pro

Question asked by VRFuser on Dec 15, 2003
Hello  all,
Ya i feel the same but the pressure to do my task is
very much, i need to show the tast as quickly as
possible and i am in hurry to do so.
could u explain me how i can learn that quickly, i
have a milhaus board installed on my system and i need
to run 8 high voltage sources and 8 registers on and
off these high voltage sources will have a range of up
to 6.5kv . Just give me an idea how i can just
represent them pictorially in vee pro and can i do it
even without connecting to the board or installing the
drivers , just initially and later i can use drivers
and boards . just for the starting purpose as an
initial be shown on the front panel of my vee
pro. how i represt them . please give me an idea.
waiting for ur reply

Do you Yahoo!?
Protect your identity with Yahoo! Mail AddressGuard

You are currently subscribed to vrf as:
To subscribe send a blank email to "".
To unsubscribe send a blank email to "".
To send messages to this mailing list,  email "". 
If you need help with the mailing list send a message to "".