AnsweredAssumed Answered

vrf NI GPIB-USB-B with Agilent I/O Libs ?

Question asked by VRFuser on Jun 13, 2004

I have just been giving a GIPB-USB-B.
I already have NI software, so NI-VISA was already installed on my PC
(Win2000).
The interface installed just like the PCI NI GPIB cards. (In fact I had
less problems) and the VEE IO manager picked it up with out any problems.
I haven't checked, but I think the install disk, may have NI-VISA on it.

Best regards
Hamish Begg
Pre-Compliance & Certification

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Eaton Powerware
39 Princess St, PO Box 11-188
Christchurch 8030
New Zealand

Phone: (++64) 3 343-3314
Fax: (++64) 3 343-5100
Email: hamish.begg@powerware.com
Website: http://www.powerware.com/
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
If you received this in error, please contact the sender and delete the
material from any computer. Any review, retransmission, dissemination or
other use of, or taking of any action in reliance upon, this information by
persons or entities other than the intended recipient is prohibited.



                                                                                                                                      
                    "Les Hammer"                                                                                                      
                    <Les.Hammer@Complet        To:     VRF <vrf@agilent.com>                                                          
                    eTest.com>                 cc:                                                                                    
                                               Subject:     [vrf] RE: NI GPIB-USB-B with Agilent I/O Libs ?                           
                    12/06/04 05:08                                                                                                    
                    Please respond to                                                                                                 
                    "Les Hammer"                                                                                                      
                                                                                                                                      
                                                                                                                                      




> Has anyone used the NI GPIB-USB-B USB to GPIB interface with the Agilent
I/O Libraries ?

I'm fairly certain that you *MUST* use NI-VISA to talk to any NI Interface.
You may have Agilent VISA installed in the side-by-side mode in addition to
the NI-VISA.



Les Hammer
Partner
Complete Test
720 SW 14th St.
Loveland, CO.  80537
Les.Hammer@CompleteTest.com



---
You are currently subscribed to vrf as: Hamish.Begg@Powerware.com
To subscribe send a blank email to "join-vrf@it.lists.it.agilent.com".
To unsubscribe send a blank email to "leave-vrf@it.lists.it.agilent.com".
To send messages to this mailing list, email "vrf@agilent.com".
If you need help with the mailing list send a message to
"owner-vrf@it.lists.it.agilent.com".




---
You are currently subscribed to vrf as: rsb@soco.agilent.com
To subscribe send a blank email to "join-vrf@it.lists.it.agilent.com".
To unsubscribe send a blank email to "leave-vrf@it.lists.it.agilent.com".
To send messages to this mailing list,  email "vrf@agilent.com". 
If you need help with the mailing list send a message to "owner-vrf@it.lists.it.agilent.com".

Outcomes