when using "read binary" in direct-IO (RS232), the read terminates when a LF character is passing by. Even when the length is given as a parameter. I know that this was on the VRF before, but a can't remember it.
kind regards, Friedrich Vllink <<Friedrich Vllink (E-mail).vcf>>
____________________________________________________________________________ This communication is intended only for use by the addressee. It may contain confidential or privileged information. If you receive this communication unintentionally, please let us know by reply immediately. Gasunie does not guarantee that the information sent with this E-mail is correct and does not accept any liability for damages related thereto. ____________________________________________________________________________
when using "read binary" in direct-IO (RS232), the read terminates when a LF character is passing by. Even when the length is given as a parameter. I know that this was on the VRF before, but a can't remember it.
kind regards,
Friedrich Vllink
<<Friedrich Vllink (E-mail).vcf>>
____________________________________________________________________________
This communication is intended only for use by the addressee. It may contain
confidential or privileged information. If you receive this communication
unintentionally, please let us know by reply immediately. Gasunie does not
guarantee that the information sent with this E-mail is correct and does not
accept any liability for damages related thereto.
____________________________________________________________________________