Dear HPvee users,
During acquisition I am trying to run a branch that, with momentaneous stop
in acquisition, changes some parameters in the acquisition and restart the
acquisition soon after.
First I tried to use Pop-up-Panels with userfunctions to change the
parameters but I did not manage to change the parameters during the run
(what it is understandable).
So I tried stopping the acquisition and then restarting again. However when
I use start-and-stop acquisition objects in an acquisition cycle, I run into
"a big wall" and I do not even start the acquisition.
Does anyone has a clue how to work this out?
Thanks for all in advance
Nuno Moreira
-------------------------------------
Nuno Moreira
DER-ITE-INETI
-------------------------------------
e-mail : nuno.moreira@ite.ineti.pt
Address : Estrada do Pao do Lumiar
1699 Lisboa Codex
Portugal
Tel. : 351.1.7162712/5141-Ext.2730
Fax. : 351.1.7163797
-------------------------------------
During acquisition I am trying to run a branch that, with momentaneous stop
in acquisition, changes some parameters in the acquisition and restart the
acquisition soon after.
First I tried to use Pop-up-Panels with userfunctions to change the
parameters but I did not manage to change the parameters during the run
(what it is understandable).
So I tried stopping the acquisition and then restarting again. However when
I use start-and-stop acquisition objects in an acquisition cycle, I run into
"a big wall" and I do not even start the acquisition.
Does anyone has a clue how to work this out?
Thanks for all in advance
Nuno Moreira
-------------------------------------
Nuno Moreira
DER-ITE-INETI
-------------------------------------
e-mail : nuno.moreira@ite.ineti.pt
Address : Estrada do Pao do Lumiar
1699 Lisboa Codex
Portugal
Tel. : 351.1.7162712/5141-Ext.2730
Fax. : 351.1.7163797
-------------------------------------