I'm using a new E36102B power supply and getting error -108 "parameter not allowed" when I'm trying to enable the output with Labview.
I can set the voltage and current limit, also initialize and close is working.
But the "Configure Output Enabled.vi" fails all the time.
I can switch the output on manually.
I have installed:
Current Version: 22.214.171.124 | 2019-11-27
Current Version: 1.0.1 | 2019-08-13
The power supply has the current firmware:
I was able to set to output on with SCPI command: OUTP ON\n
This would be my only workaround to use directly the SCPI commands for all settings.
The vi which I downloaded uses the function AgE36xx_ConfigureOutputEnabled from the DLL AgE36xx**.dll
Does anyone have the same error, or may be gives me a hint?