AnsweredAssumed Answered

Abort calibration sweep

Question asked by pezet on Jan 10, 2019
Latest reply on Jan 10, 2019 by daras

Hello,

I am using N5242A with A.09.90 firmware. I would like to abort calibration sweep in Guided mode. I tried ABORt command but it does not work. It is possible to use SOURce<ch>:POWer<port>:CORRection:COLLect:ABORt command during unguided power cal. I found it is possible to abort Guided calibration between sweeps using SENSe<ch>:CORRection:COLLect:GUIDed:ABORt. This command causes PNA firmware crashes when executed during sweep.

Is it possible to abort calibration sweep in Guided Calibration?

Best regards,

Pawel

Outcomes