Skip navigation


Top & Trending
When I measure a 1uH inductor at 100kHz, the Q measurement jumps all over the place. How can I get an average?  

Go straight to the Knowledge Center article (login required): How to Create your own 3D Smith Chart Plots --------------------------------------- Engineers surround themselves with the best tools they can find. For the RF engineer, a new tool discussed in the literature recently is the Cylindrical 3D Smith Chart (also called the
Top & Trending
HP8591E  drift at zero span  Hi everybody how are you? As the title,  is the problem that I found in my recently acquired SA Done all self calibration procedure. TG calibration Amplitude Calibration Frequency Calibration       Setting the TG to 10.000 Mhz at zero span   Counter show at list 7.61 Khz
Top & Trending
I just purchased a U1733C, LCR meter and for the most part, it works fine.  However, I'm questioning the accuracy.  It reads OK with electrolytic capacitors up to 1uF but with values higher than that, the accuracy degrades.   The meter settings are, 100hz frequency, series capacitance and before the measurements, I calibrate